J System Synthesizer TC-2 Trigger Interface - S-Trig to V-Trig

The TC-2 converts an S-Trig or +V to GND gate or trigger signal to a positive going V-Trig or gate signal.

The V-Trig output voltage is dependent on the DC power supply used - a 9v supply will give a gate voltage of approx 9v, a 12v psu will give approx 12v gate voltage etc. Most synths will trigger fine with 9v but some may require a higher voltage - check your synth's manual for specific details.

Requires a DC power supply in the range from 5v to 12v (not supplied). A multi voltage type PSU is perfect. Not included.

ABS case with rubber feet. Standard 6.35mm (1/4") jack sockets. DC 2.1mm jack, NEGATIVE centre/tip.