AMPLIFICADOR ETAPA DE POTENCIA 250W X 4 (4 OHM) - MC2 (T4-250)
600€
El anuncio ha sido retirado.
Otros anuncios que te pueden interesar
-
Etapa de potencia 4 canales DAP audio en Zaragoza240 €
-
800 €
-
Equipo de sonido DAS + Etapas Behringer en Madrid1400 €
-
Prism Sound Lyra 2: Interfaz USB 2/4 con 2 previos en Barcelona2000 €
-
Etapa Behringer epx 4000 en La Rioja260 €
Designed for use in multi-zone installations, where sonic quality and reliability are the highest priorities. The T4-250 is a 4 x 250W amplifier housed in a 2U chassis and has been designed with complementary AB bipolar outputs, using the unique MC2 current driven floating drive stage and conventional analogue level controls.
The sound quality is maintained over a very wide range of load and temperature conditions. Sophisticated 'side chain' limiters prevent distortion and speaker damage but are out-of-circuit until the onset of clipping.
The control circuitry provides full protection against short circuits, DC and excessive temperature together with inrush current limiting and delayed 'turn on'.
-Complementary class A/B bipolar outputs, using the unique MC2 current driven floating drive stage, which gives one of the 'cleanest' sounds available.
-Sophisticated monitoring of amplifier temperature and load conditions.
-Proprietary control and protection circuitry continuously checks for all fault conditions such as shorted outputs, DC on outputs, excessive temperature (blocked air flow), component failure etc… and disconnects the outputs, if such an event occurs.
-Low noise vari-speed fans.
-Side-chain' clip limiter prevents speaker damage from clipped signals but only comes into the signal path during limiting, and is inaudible during normal operation.
-Audio 'fade-up' on Power-on.
-Optional internal crossover cards available.
-New proprietary 'Ultra Cool' heatsink.
-Full mains inrush protection.
-Full 5-year warrant
Connectors
Inputs: XLR 3 pin
Outputs: 4-pole Speakon
Controls
Rear Panel: 1 x stereo/bridged mono switch
Front Panel: 4 level controls, 1 x power on/off switch
Indicators: 1 x power, 4 x limit, 4 x signal present
1 x auto protect, 1 x bridged
Output Power (Watts RMS) per channel :
8 ohms @ 1kHz: 175
4 ohms @ 1kHz: 250
2 ohms @ 1kHz:
400 (Ch. C & Ch. D ONLY)
Mono Bridged
8 ohms @ 1kHz: 550
4 ohms @ 1kHz: 800
THD @ Rated Power 4 ohms
1 kHz: < 0.008%
20Hz - 20kHz: < 0.03%
Input CMRR: > 90 dB
Hum & Noise: -105 dB
Gain: +32dB
Sensitivity for rated output, 4 ohms: +1dBu (870mV)
Damping Factor 1 kHz, 8 ohms: > 400
Frequency Response: 20Hz-20kHz +0/-0.5 dB
Input Impedance
(actively balanced): 20k ohms
Dimensions - 2U(mm): 88 x 482 x 428
Weight: 18kg
Power Requirement: 230 VAC @ 8.0 amps max
115 VAC @ 16.0 amps max
The sound quality is maintained over a very wide range of load and temperature conditions. Sophisticated 'side chain' limiters prevent distortion and speaker damage but are out-of-circuit until the onset of clipping.
The control circuitry provides full protection against short circuits, DC and excessive temperature together with inrush current limiting and delayed 'turn on'.
-Complementary class A/B bipolar outputs, using the unique MC2 current driven floating drive stage, which gives one of the 'cleanest' sounds available.
-Sophisticated monitoring of amplifier temperature and load conditions.
-Proprietary control and protection circuitry continuously checks for all fault conditions such as shorted outputs, DC on outputs, excessive temperature (blocked air flow), component failure etc… and disconnects the outputs, if such an event occurs.
-Low noise vari-speed fans.
-Side-chain' clip limiter prevents speaker damage from clipped signals but only comes into the signal path during limiting, and is inaudible during normal operation.
-Audio 'fade-up' on Power-on.
-Optional internal crossover cards available.
-New proprietary 'Ultra Cool' heatsink.
-Full mains inrush protection.
-Full 5-year warrant
Connectors
Inputs: XLR 3 pin
Outputs: 4-pole Speakon
Controls
Rear Panel: 1 x stereo/bridged mono switch
Front Panel: 4 level controls, 1 x power on/off switch
Indicators: 1 x power, 4 x limit, 4 x signal present
1 x auto protect, 1 x bridged
Output Power (Watts RMS) per channel :
8 ohms @ 1kHz: 175
4 ohms @ 1kHz: 250
2 ohms @ 1kHz:
400 (Ch. C & Ch. D ONLY)
Mono Bridged
8 ohms @ 1kHz: 550
4 ohms @ 1kHz: 800
THD @ Rated Power 4 ohms
1 kHz: < 0.008%
20Hz - 20kHz: < 0.03%
Input CMRR: > 90 dB
Hum & Noise: -105 dB
Gain: +32dB
Sensitivity for rated output, 4 ohms: +1dBu (870mV)
Damping Factor 1 kHz, 8 ohms: > 400
Frequency Response: 20Hz-20kHz +0/-0.5 dB
Input Impedance
(actively balanced): 20k ohms
Dimensions - 2U(mm): 88 x 482 x 428
Weight: 18kg
Power Requirement: 230 VAC @ 8.0 amps max
115 VAC @ 16.0 amps max
OfertasVer todas
-
-26%AKAI MPC Key 611.290 €Ver oferta
-
-8%Behringer X Air XR18645 €Ver oferta
-
-40%¡Precio mínimo histórico! AKAI MPK 261298 €Ver oferta