J System Synthesizer TC-2 Trigger Interface - S-Trig to V-Trig
Por ERDE80 el 29/12/2017 en Madrid
Expiración: 06/07/2018 | Visto 295 veces
25€
Este anuncio ha expirado.
Otros anuncios que te pueden interesar
-
BOSS PC-2 Percussion Synthesizer en Madrid200 €
-
Rakit Drum Synth en Madrid100 €
-
2 PS15 +1 Rack + pane +Utd +Vortex 4 en Guadalajara3300 €
-
NEXO GEOD 8 cajas + 4 CD18 +NXAMP en Guadalajara33000 €
-
LD SYSTEM MEI1000 en León100 €
The TC-2 converts an S-Trig or +V to GND gate or trigger signal to a positive going V-Trig or gate signal.
The V-Trig output voltage is dependent on the DC power supply used - a 9v supply will give a gate voltage of approx 9v, a 12v psu will give approx 12v gate voltage etc. Most synths will trigger fine with 9v but some may require a higher voltage - check your synth's manual for specific details.
Requires a DC power supply in the range from 5v to 12v (not supplied). A multi voltage type PSU is ideal.
Not included.
ABS case with rubber feet. Standard 6.35mm (1/4") jack sockets. DC 2.1mm jack, NEGATIVE centre/tip.
Envío a cargo del comprador o entrega en mano en Madrid.
The V-Trig output voltage is dependent on the DC power supply used - a 9v supply will give a gate voltage of approx 9v, a 12v psu will give approx 12v gate voltage etc. Most synths will trigger fine with 9v but some may require a higher voltage - check your synth's manual for specific details.
Requires a DC power supply in the range from 5v to 12v (not supplied). A multi voltage type PSU is ideal.
Not included.
ABS case with rubber feet. Standard 6.35mm (1/4") jack sockets. DC 2.1mm jack, NEGATIVE centre/tip.
Envío a cargo del comprador o entrega en mano en Madrid.
Usuario
Registrado 08/10/2011
Comentarios32
Temas3
Posts en foros56
Seguidores33
Fotos13
Mercasonic Score